Injection-moulded artificial turf mainly adopts injection molding process and is suitable for kindergartens and sports grounds.
Into the woven base fabric, this is mainly suitable for leisure venues, golf venues, garden floors and green ground.
No matter what kind of fake turf, it must be carried out in accordance with the construction plan during construction, so as to ensure The laying of artificial turf is reasonable and fast. Next, I will briefly introduce the construction steps of artificial turf.
1. Measuring and setting out
When laying the imitation grass early, we should first measure the line.
When measuring the line, we must carefully and cleanly draw the line on the surface of the field according to the size of the drawing.
Note that some marking lines should be double lines.
Tools used: ink fountain, marker pen, steel tape measure, cement nail, hammer
2. Preparation of the imitation lawn turf
We will place the straw rolls in the location required by the construction according to the requirements on the drawings
Tools used: confirmed drawings.
3. The unfolding and trimming of straw rolls
We need to compare the production design with the paving drawings,
and pave the produced straw rolls according to the manufacturer's paving drawings.
After unfolding and finishing and confirming that there are no wrinkles or distortions, the excess edges of the straw rolls are cut off and cut. Afterwards, ensure that the width of the grass roll is not less than 4 meters, and at the same time, ensure the straightness, and then place the second grass roll into the designated position to unfold.
When unfolding plastic grass, put the extra side of the grass on the first roll of lawn, and then Cut off the overlapping part of the first roll, and trim the other side neatly. In order to ensure the beauty of the site, the lawn should be placed as tightly as possible, but there should be no overlap after trimming. At the same time, it should be ensured that the lawn and the grass on the edge of the lawn cannot be too far apart, as far as possible. distance.
Tools used: confirmed drawings.
4.Bonding seam tape
We evenly fold up the rolled edges of the serial numbered grass 20 to 30 cm, put the prepared 20cm wide seam tape on the foundation between the adjacent grass rolls, and then evenly spread the glue, until the glue is about to solidify Previously, manually step back and forth on the seam edge or use other methods to press hard to make the seam edge, glue, and seam tape fully bonded.
5. Cutting of the marking line
Find the marking line to be reserved on the faux grass, cut it with a knife in the middle of the marking line, and allow it to shrink naturally for a period of time (the shrinkage time is about half a day or the day later) with a utility knife along the drawn partition The position of the marking line.
Tools used: knife
6.Bonding marking line
Cut the rolled white lawn into strips of corresponding width, put it into the reserved mark line position, and then glue it with the green artificial lawn next to it with a 30cm wide seam tape. The process is basically the same as the bonding of the green grass seam.
Tools used: utility knife, squeegee
If need more useful artificial grass knowledge and information, Please feel free to contact
Contact person:Lemon Wang
Mob./Whats app: +86 189 1653 4027
Email: sales6@geegrass.com